If you have a metal roof, there is a good chance you will eventually need to repair it. Metal roofs are durable and can last for many years, but they require occasional maintenance. This comprehensive guide will walk you through the steps necessary to repair your metal roof. We will cover everything from identifying the problem to fixing the damage. So whether your roof is leaking or has been damaged by a storm, follow these steps, and you will be good as new in no time!
Have You Experienced Roof Leaks On Your Metal Roof System?
Metal roofs are highly durable, but they require maintenance and occasional repairs to keep them looking their best. If you have recently had some heavy rain or hail damage done to the area around your house, then there was likely enough water getting through the shingles for long periods, causing rust spots and corrosion from oxidation (rust).
How To Repair A Metal Roof
If there are large holes in the shingles, then it’s likely that some of them will need to be replaced. It is usually an easy repair and can often be carried out by yourself if you access a ladder or scaffolding.
If you experience these issues open seams, open penetration flashings, metal roof oxidation, fastener backout, open ridge/headwall flashing, loose counterflashing, improper installation methods, panel damage, you should follow our step by step guide:
Clean the Repair Area
The first step is to clean the area that you will be repairing. Use a wire brush to remove any rust or debris from the surface. A hole in a metal roof can be created by rust, corrosion, or damage to the metal. Thoroughly clean the area to make sure the new metal will adhere properly.
Scuff the Metal
Use a scouring pad or sandpaper to scratch the surface of the metal around the hole. It will create a rough surface that will allow for good adhesion of the new piece of metal. A properly scuffed area should look dull and grey. Make sure that you do not remove too much paint, just enough to expose the bare metal.
Measure the Repair Area and Cut a Patch
Look for a piece of metal similar to the one you are repairing. Measure how large your patch needs to be and cut it from this new sheet of metal. If there are no pre-painted pieces available, paint the area around the hole with primer before applying any putty or patching material.
Install the Repair Patch
Apply a liberal amount of adhesive around the hole. Make sure that you apply an even coat of adhesive past the hole’s edges so that it covers any exposed metal. Affix your patch in place and firmly press down on it to make sure that the patch is securely attached to your roofing system. Apply additional putty or caulk as needed to cover any seams left by your repair patch.
Tools and Supplies You Need
You will need a few basic tools to complete this project: utility knife, hammer, screwdriver, tape measure, wire brush, caulking gun, putty knife (or other small flat blades), and pliers. In addition, you will need some materials that are specific to your type of roofing material. Make sure you have the following on hand before starting your repair.
Conclusion
Metal roofs are becoming an increasingly popular option for homeowners, and for a good reason. They are durable, long-lasting, and can be a great way to add value to your home. If you have a metal roof and it starts to leak, do not worry – we have got you covered. If you are still experiencing problems with your metal roof, please get in touch with our metal roof repair specialist.
